The Cables and Twists jumper turned out to be a bit of a steep learning curve. I had cabled before but never so many different types on one garment - it could be difficult to keep track of the pattern which ran over something like 26 rows, each one a little different, especially when tired.
Suffice to say I made a few mistakes. Some weren't that visible such as some around the neck shaping, so I left them as a fitting tribute to my cabling education. Others were obvious, such as a knit stitch on the purl section or a completely forgotten cable crossover. This taught me some other tricks for correcting mistakes in your work - I unravelled the offending stitches right back to the offending row and then reknit them all the way back up again. It doesn't look perfect, but it's better than the original mistake! I also had the common problem of a loose stitch on the left of each cable. Is it true you can knit into the back of a stitch to tighten it? I'm not sure, but I was never able to solve this problem.
When I had finally finished the knitting and sewing up, I tried it on and realised it was way too short for my liking. I had achieved the correct tension by going up a needle size, so it wasn't that. I can only assume that either I have a long body or I just don't like the fashion for short jumpers that seems to be prevalent in a lot of knitting patterns these days. I just don't see how it is flattering to stop half way down your waist - I like to have at least a bit of my hips covered.
I knew that in its current state I would never wear the jumper, and after all that work I wanted at least to be able to wear it casually/around the house even if it wasn't fit for best. So I took a deep breath and made the scary decision to cut into my work and pick up the stitches above the bottom ribbing, with the help of the excellent Tech Knitting blog. This was not the easiest project to do this with as the cables started just above the rib, so I have to admit I fudged it a bit. Since the garment was already sewn together I just unpicked the seam to above the section I was cutting, then knit downwards in rib in the round. It does all sound a bit botch job, which it is, but it turned out alright and you would have to look closely to see the errors.
I used every last scrap of yarn to add length, even the unravelled pieces. I added about two inches, and would have added more if I had any yarn left as I still think its a bit short. But I was proud of myself for actually cutting my knitting and for all the techniques I had learned.
It's not my favourite jumper - it looked good in the book on the skinny model but the cabling on the arms and drop shoulders make me look a bit like a rugby player, especially combined with the short length! I will have to be more careful with my pattern selection in the future. But it's soft and warm and fine for sobbing around the house in.
In other news, J's Stripy Jacket is finished and I have cast on something new...
Posted with Blogsy
